MKS MKSINST IE1000A, Инструкция по эксплуатации

Страница: 63 / 75

Chapter Five: Diagnostic Interface Setup, Configuration,
and Operation Setup Mode
55
Setup Mode / Configuration Page
As was noted earlier, the Configuration Page is where you are initially directed once you’ve entered “Setup
Mode.” Here the MFC can be zeroed, the “Setup Mode” password can be changed, changes can be made to
the Ethernet settings and firmware can be updated.
Figure 24: IE1000A Embedded Interface (Setup Mode / Configuration Page)
Setup Mode / Configuraton Page / Zeroing the MFC
For the MFC there will be a “Zero Flow” option. Before zeroing the value make sure the “Zero Adjustment”
procedure has been followed correctly. To zero the flow, press the “Zero Flow” button. A green banner across
the top of the page will tell you if the device received the command and is processing. Zeroing typically will
take (10) seconds. The MFC will be unresponsive during this time.
Caution
Zeroing the flow incorrectly can cause system failure. Make sure that the “Zero
Adjustment” procedure is followed properly.
Setup Mode / Configuraton Page / Changing the Setup Mode Password
To change the “Setup Mode” password from the default password “config,” follow the steps in the “Change
Setup Password” section.
Setup Mode / Configuraton Page / Changing the Ethernet (TCP/IP) Settings
The TCP/IP section allows you to change the IP Address, Subnet Mask, and Default Gateway for the MFC.