MKS MKSINST IE1000A, Инструкция по эксплуатации

Страница: 59 / 75

Chapter Five: Diagnostic Interface Setup, Configuration,
and Operation Setup Mode
51
Setup Mode
In “Setup Mode” the user is able to configure the MFC, i.e. zero the device, change the IP address, configure
the PID parameters, etc. To enter this mode, while in “Monitor Mode”, go to the “Configuration Page” and
enter the Factory-shipped password “config” (without “”). Once you press the “Change Settings” button you
will be directed to the “Configuration Page” in “Setup Mode.” You should now a see a green banner that lines
the top of the page that says, “The device is now in SETUP mode.”
Each of the pages, i.e. tabs, in “Setup Mode” are listed and described below in detail starting with the Device
Page. Please note that this section will only describe in detail the features that are different from those in
“Monitor Mode.” For a complete understanding of each page, also read the
Monitor Mode section.
Figure 19: IE1000A Embedded Interface (Setup Mode / Configuration Page)