Mitsubishi Electric FR-D700 Series, Инструкция по эксплуатации

Страница: 34 / 290

23
2
WI
RI
NG
Control circuit specifications
2.3.3 Wiring of control circuit
(1) Standard control circuit terminal layout
(2) Wiring method
Wiring
Use a bar terminal and a cable with a sheath stripped off for the control circuit wiring. For a single wire, strip off the sheath of
the cable and apply directly.
Insert the bar terminal or the single wire into a socket of the terminal.
1) Strip off the sheath about the size below. If the length of the sheath peeled is too long, a short circuit may occur among
neighboring wires. If the length is too short, wires might come off.
2) Crimp the bar terminal.
Insert wires to a bar terminal, and check that the wires come out for about 0 to 0.5 mm from a sleeve.
Check the condition of the bar terminal after crimping. Do not use a bar terminal of which the crimping is inappropriate, or
the face is damaged.
Introduced products on bar terminals :(as of Mar., 2008)
Bar terminal crimping tool: CRIMPFOX ZA3 (Phoenix Contact Co., Ltd.)
Recommend cable size:
0.3mm
2 to 0.75mm 2
Wire the stripped cable after twisting it to prevent it from
becoming loose. In addition, do not solder it.
Wire Size (mm
2
)
Bar Terminal Model
Maker
With Insulation Sleeve Without Insulation Sleeve
0.3, 0.5 AI 0,5-10WH —
Phoenix Contact Co.,Ltd.
0.75 AI 0,75-10GY A 0,75-10
1 AI 1-10RD A1-10
1.25, 1.5 AI 1,5-10BK A1,5-10
0.75 (for two cables) AI-TWIN 2 x 0,75-10GY —
STF STR PC SD RH RM RL
AM
C B A
10 2 5 4
RUN SE S1 S2 SC SO SD
Cable stripping size
10mm
Sleeve
Shell
Cable
Unstranded
wires
Damaged
Wires are not inserted
into the shell
Crumpled tip