Mindray Anesus ME7T, Руководство оператора

Страница: 220 / 312

16 - 12 Operator’s Manual
16 Probes and Biopsy
4. Wipe away the residual disinfectant on the probe by using a piece of lint-free soft cloth soaked
with clean water. Wipe three times. Or rinse the probe thoroughly by using a large amount of
clean water (about 7.5 L/2 gallons) at room temperature.
5. Dry the probe by wiping with a piece of disposable lint-free soft cloth. Do not dry the probe by
heating.
6. Check whether the probe has defects such as peeling, rifts, bumps, cracks, or liquid spill. If
such defects exist, the probe has reached the end of its service life. In this case, stop using it
and contact the Mindray service department.
7. Store the probe in a cool, clean and dry environment. And repeat the cleaning and disinfection
process before the next use.
High-level disinfection of a semi-critical probe
Perform the following procedure:
1.
Wear a pair of gloves to prevent infection.
2. Clean the probe thoroughly in accordance with the cleaning procedure before disinfection.
3. Disinfect the probe by using an appropriate high-level disinfectant or system. For how to use a
high-level disinfectant or system, see the operator’s manual provided by the manufacturer.
Prepare a disinfectant by using sterile distilled or softened water when necessary.
– Soaking: Immerse the probe head in the disinfectant and shake the probe appropriately to
remove any bubbles on the probe surface. For details about the probe immersion duration,
see the operator’s manual provided by the manufacturer.
Observe the graph here carefully to immerse the probe. Only soak parts of the probe
below the strain relief.
Connector
Strain relief
Probe handle
Strain relief
Fluid level