Mediana YM6000, Руководство по обслуживанию

Страница: 65 / 100

Troubleshooting 59
YM6000 Service Manual
Alarm Messages Check Items
added to cuffs. Considering above, measure again.
NIBP: Retry, Check cuff,
hose and mode (C21)
Patient to be measured, and cuff size used, do not match. This
error may occur if the blood pressure measurement mode setting
is incorrect, if the cuff has been applied tightly in the adult mode
loosely in the neonatal mode or if the arm has been bent during
measurement. Check the measurement mode setting and
application of the cuff, and measure again.
{label} : No zero reading. Perform the pressure zero setting.
SpO
2
: Motion artifact. SpO
2
could not be measured due to signal noise thought to be
due to body movement. Ensure that the patient remains at rest,
and measure again.
SYSTEM: No recorder
paper.
In case the recorder door is open, close the door.
In case the recorder paper is empty, insert new paper and close
the door.
SYSTEM: Abnormally
shut down last time.
The monitor has been abnormally shut down last time.
When power is lost for less than 30 seconds, the monitor
will preserve the current settings and trend data restored
automatically before the power loss. However, if the
power loss is over 30 seconds, the monitor will be back to
the previous user settings (or the factory default settings)
as per the ‘save settings on power off’ in the service menu.
Contact qualified personnel in your facility or your local
supplier.
SYSTEM: No recorder
installed.
The recorder is not installed in your monitor. If required, contact
your local supplier.
Note: If the alarm message still appears, contact your local supplier for advice on
remedial action.