Mediana YM6000, Руководство по обслуживанию

Страница: 60 / 100

54 Troubleshooting
YM6000 Service Manual
Firmware Download
If the error code appears during the firmware downloading, take the following action.
Table 16. Firmware Downloading Error Codes
Code Description Action
I. 1. 3 / E. 1. 3 When an error is occurred
during transferred data.
Check the LAN cable and settings
then Retry boot download
I. 2. 3 / E. 2. 3 When an error is occurred
during transferred of data.
Check the LAN cable and settings
then Retry boot download
E. 1. 5 When an error is occurred
during recorded data.
Retry boot download
E. 2. 5 When an error is occurred
during recorded data.
Retry main download
E. 1. 7 When the data is broke down
during boot download.
Retry boot download
E. 2. 7 When the data is broke down
during main download.
Retry main download
Note: If the Error Code still appears, take monitor out of service and contact Mediana
Technical Service Department for advice on remedial action
Technical Alarm Conditions
When the monitor detects the technical alarm condition, the monitor will display the
alarm message on the screen.
If the alarm message occurs, follow the check items in the below table to remove the
alarm condition after checking the alarm message in the alarm message area or
informative message area.
Table 17. Alarm Messages and Check Items
Alarm Messages Check Items
NIBP: Check cuff (C11) Cuff pressure did not increase enough even after activating the
pump for more than 30 seconds (adult). There is a possibility that
a cuff hose is disconnected, or a cuff may not be wrapped around
an arm. Check cuff and cuff hose.
This error possibly occurs in case of large cuffs that are wrapped
around loosely.
When the error still occurs even after checking above, there is a
possible air leakage from a ruptured cuff.
Replace it with a new one.
NIBP: Check cuff / Patient
(C12)
Blood pressure could not be measured even after cuff pressure
decreased. It is possibly because pulse was not strong enough for
measurement, or because change of pulse amplitude could not
be obtained. Check whether cuffs are not wrapped around thick
clothing. After wrapping cuffs around property, measure again.
When the error occurs in the initial measurement in continuous
mode, the second measurement will start unless Stop button is
pressed.
NIBP: Cuff excessive
artifact (C13)
Measurement failed because of patient movement during
measurement. Tell the patient to stay still, then, measure again.
When it occurs in the initial measurement in continuous mode,
the second measurement will start unless Stop button is pressed.
NIBP: Cuff insufficient Measurement failed because of insufficient pressurizing. There is