Mediana YM6000, Руководство по обслуживанию

Страница: 61 / 100

Troubleshooting 55
YM6000 Service Manual
Alarm Messages Check Items
pressure (C14) a possibility that standard cuff pressure might be detected
wrongly due to noises, motion artifact or external vibration.
Check whether cuffs are not wrapped around thick clothing,
whether the patient is moving and whether cuffs are free from
outside vibrations, then, measure again.
When it occurs in the initial measurement in continuous mode,
the second measurement will start unless Stop button is pressed.
NIBP: Cuff irregular
pulses (C15)
Blood pressure could not be measured because oscillation graph
was not normal. There is a possibility that motion artifact or
vibration from outside might interrupt the measurement.
Check whether the patient stays still and cuffs are free from
external vibration, then, measure again.
When it occurs in the initial measurement in continuous mode,
the second measurement is continued unless Stop button is
pressed.
NIBP: Cuff motion artifact
(C16)
Blood pressure could not be measured because noises
interrupted pulse waveform signal. Check for motion artifacts, or
external vibration and then, measure again.
When it occurs in the initial measurement in continuous mode,
the second measurement will start unless Stop button is pressed.
NIBP: Cuff time ‐ out (C17) Measurement was preventively stopped because measurement
time exceeded 160 seconds (adult), There is a possibility that
blood pressure might be repeatedly measured due to insufficient
pressurizing caused by calcified pseudohypertension.
NIBP: Cuff time ‐ out, over
160 pulses (C18)
Pulse waveform signal more than 160 beats are detected during
measurement. There is possibility that noises might interrupt
signal.
Motion artifact or external vibrations possibly affected cuffs.
Check for patient movement and if the cuff is free from stays still
and cuffs are free from outside vibration, then, measure again.
NIBP: Cuff pressure
failure (C19)
Cuff pressure exceeded more than 300 mmHg (adult) during
measurement.
There is a possibility that the patient moved during
measurement or strong pressure from outside might be added to
cuffs. Considering above, measure again.
NIBP: Cuff weak pulse
(C20)
Amplitude of pulse obtained from cuffs are too weak.
This error possibly occurs when cuffs are wrapped around
loosely in ASO patients or when cuffs are wrapped around thick
clothing.
Wrap cuffs around properly, then, measure again.
NIBP: Check cuff, hose
and mode (C21)
Patient to be measured, and cuff size used, do not match.
This error may occur if the blood pressure measurement mode
setting is incorrect, if the cuff has been wrapped tightly in the
adult mode, loosely in the neonatal mode or if the arm has been
bent during measurement.
Check the measurement mode setting and application of the cuff,
and measure again.
NIBP: Internal error (E03) NIBP module error
BPM pressure sensor fault.
Pump operated for ten seconds, however pressure does not
change. Check the connection of the cuff hose.
NIBP: Internal error (E07) Reboot the monitor. If the problem persists, cease use
immediately and contact qualified service personnel or your
local supplier.