CrossCore® Safety Procedures & Instructions
|
vi
© 2016 Mad Dogg Athletics, Inc. All rights reserved.
CrossCore® User Guide & Manual
13. When not in use, it is recommended that the CrossCore is:
a. Removed from its anchor point and stored in the carry bag away from water or moisture.
b. Remaining in hanging position, then the adjustable handles/foot and arm cradles are closed so
the handles are flush with the straps and there is no loop in them. Clip the carabiners to carabiner
openings in the pulley housing. This will help keep handles away from young children and help pre-
vent a choking hazard. Additionally, it will keep the handles out of reach of dogs who have shown
a liking to chew handles on occasion.
14. CrossCore® Ceiling and Wall Mount Installation:
INSTALLATION BY A LICENSED CONTRACTOR IS RECOMMENDED.
a. For CrossCore installation, we recommend mounting only to a load bearing wall or ceiling beams
able to bear a weight load of at least 300 lbs. (136.1 kilos) per CC unit. If more than one CrossCore
ceiling and wall mount will be attached to a single beam for multiple users, CrossCore STRONGLY
RECOMMENDS using a licensed contractor for installation that will confirm that the combined user
weight will not compromise the structural integrity of the beam or attachment points at any time.
b. Each time that you use the product, inspect the CrossCore ceiling and wall mount and the oper-
able parts of the product in order to insure that the product is safe for its intended usage.
Never
use CrossCore on a loose or improperly installed CrossCore® ceiling and wall mount
.
c. Installed CrossCore® wall/ceiling anchor mount should be secured completely flush to wall/ceiling
with no movement. Carefully perform a weight test prior to using installed CrossCore® wall/ceiling
anchor mount.
d. Use a stud finder at several points along stud to be certain of its center.
e. Wood lag bolts are NOT meant for installation into concrete or steel.
If attaching to wood studs
and using wood lag bolts, maximum weight load for all persons using the CrossCore® ceiling and
wall mount must not exceed 300 lbs. (136.1 kilos) per anchor mount
.
15. CrossCore® Home Kit, Door Strap, and Door Pad Use and Installation:
Warning! Do not use the door strap and door anchor on sliding doors, glass doors, lightweight closet
doors, double doors or doors that have a large gap of a 3 inches or more between door and frame. Make
sure that the door cannot be opened without completely turning the door handle. door strap and door
Anchor can ONLY be used on a strong and solidly constructed door that can support the users total body
weight
. Make sure not to slam or drop pulley or handles/foot and arm cradles against the door after per-
forming each exercise as this can damage the door.
Perform weight test by pulling the strap to make sure door is securely closed and that door strap and door
anchor are secure prior to performing any exercise.
Содержание crosscore
Страница 1: ...USER GUIDE OWNER S MANUAL...
