LumaSense technologies Innova Type 1314i, Инструкция по интерфейсу

Страница: 42 / 81

Chapter 2
_________________________________________________________________________________________
_________________________________________________________________________________________
BB6032-14 Photoacoustic Gas Monitor LumaSense Technologies
1314i / 1412i / 1512 / 3434i Page 42 of 81
2.3.32 RELAY
R? indicates the control over the relays. Two outputs
are possible:
Yes the relays will be controlled via the interface
No the relays will be controlled by the Monitor.
R? 1 indicates the condition of the relays, when the relay
number is included, for example, R? 1, then
condition of Relay 1 will be readout. Two outputs are
possible:
Yes active
No inactive
/***** PROTECTED 59 *****/ (see section 2.3.14 )
The control over the relays can be set using R, If the number is left out, for
example:
R,Y
Yes the relays will be controlled via the interface
No the relays will be controlled by the Monitor.
The relay(s) condition can be set using R. If the relay number is specified,
for example:
R 1,Y
Then the relay specified can be set as shown below:
Yes active
No passive