LumaSense technologies Innova Type 1314i, Инструкция по интерфейсу

Страница: 10 / 81

Chapter 1
_________________________________________________________________________________________
_________________________________________________________________________________________
BB6032-14 Photoacoustic Gas Monitor LumaSense Technologies
1314i / 1412i / 1512 / 3434i Page 10 of 81
1.1 The Monitor’s Interface Ports
The interface ports, USB, Ethernet (TCP/IP) and RS-232 are located on the
rear panel of the Monitor, see Fig. 1.1.
Fig. 1.1 The interface connections on the rear panel of the Monitor
WARNING! Before connecting any cables to the Monitor, ensure that the
power to the Monitor is turned off. Cabling to the Monitor is covered in more
detail in the Instruction Manual.
1.2 The USB Interface
The USB interface is designed in accordance with the USB specification,
revision 2.0 (Full-speed).
It supports hot plugging and dynamic configuration of the device, meaning
that Gas Monitor device can be connected to a USB cable while power is on.
The USB interface of the Monitor acts as a device controller, thus it can be
connected to an USB host controller (typically in a PC), through an USB
cable.
Interface Connector
The interface connector Fig. 1.3 is a Standard Type B USB connector. It is
located on the rear panel of the Monitor as shown in Fig. 1.1 . Next to
interface connector the USB interface symbol is displayed, as shown in Fig.
1.2 . Pin definitions are given in Table 1.1 .