Chapter 2
_________________________________________________________________________________________
_________________________________________________________________________________________
BB6032-14
Photoacoustic Gas Monitor
LumaSense Technologies
1314i / 1412i / 1512 / 3434i
Page 28 of 81
2.3.7 CURRENT_FILTER
C_F? reads out the “filter id”. This indicates which filter (gas) is currently in
use.
For example:
If the Monitor is using the water filter, C_F? will cause the
Monitor to output F_W.
C_F determines which filter (gas) is displayed.
For example:
C_F,F_A causes filter (gas) A to be displayed.
2.3.8 CURRENT_SETUP
CU_SE? reads out the number of the active “Measurement Task” on the
display. The output from the Monitor will be an integer, NR_1 (1..10).
CU_SE defines which “Measurement Task” will be active.
For example: CU_SE 5 defines that measurement task 5 is active.
2.3.9 DELETE_MEASUREMENT
D_M erases the contents of the defined Memory Location, NR_1 (1..10),
from the background memory.
2.3.10 DHCP
DHCP?
Reads out the Monitors IP address set by the DHCP server
i.e. DHCP? Responds: 192.168.000.092
2.3.11 DISPLAY_AVERAGE
D_A? indicates the state of the average function. The output from the
Monitor can be Yes (average function is active) or No (average function is
inactive).
D_A followed by a Yes or a No defines the state of the average function.
2.3.12 DISPLAY_STATE
D_S? indicates which display buffer is being displayed on the Monitor. The
output (display id) from the Monitor is one of the following:
POp_Up Used for error/status/reset messages.
REMote
The content is chosen via interface.
SYstem
Default display.
