Lucent Technologies B-STDX, Руководство по установке

Страница: 50 / 170

Beta Draft Confidential
3-8 B-STDX, CBX, and GX Network Management Station Installation Guide
Sybase Prerequisite Tasks
Partitioning the Disk(s) to be Used for Sybase Using Raw Partitions
Creating a Tempdb Device on Partition 3
To create a tempdb device for Sybase on Partition 3:
1. At the
partition
prompt, enter
3
.
2. At the
Enter partition id tag
prompt, enter
unassigned
.
3. At the
Enter partition permission flags
prompt, enter
wm
.
4. At the
Enter new starting cyl[xxxx]:
prompt, enter:
<
a number equal to the value of the ending cylinder from
partition 0 plus 1 >
(Using Figure 3-3 on page 3-12 as an example, this value would be
116
.)
5. At the
Enter partition size
prompt, enter
1GB
.
6. At the
partition
prompt, view the partition table by entering
print
.
Partition 3 is complete.
Figure 3-3 on page 3-12 is an example of a completed partition table after all 5
partitions have been defined.
7. Proceed to “Creating a Sysprocsdev device on Partition 4.”
Creating a Sysprocsdev device on Partition 4
To create a sysprocsdev device for Sybase on Partition 4:
1. At the
partition
prompt, enter
4
.
2. At the
Enter partition id tag
prompt, enter
unassigned
.
3. At the
Enter partition permission flags
prompt, enter
wm
.
4. At the
Enter new starting cyl[xxxx]:
prompt, enter:
<
a number equal to the value of the ending cylinder from
partition 3 plus 1 >
(Using Figure 3-3 on page 3-12 as an example, this value would be
701
.)
5. At the
Enter partition size
prompt, enter
200MB
.
Note – Although Lucent recommends that you allocate 1 GB to partition 3 ( step 5 ),
this number depends on your disk space availability. A partition size of 200MB is the
minimum value for the Tempdb Device.
Note – The default system name for this device is sysprocsdev. However, it is
frequently referred to as the sybsystemprocs device since it stores the sybsystemprocs
database.