LPKF ProtoMat C 30-S, Руководство пользователя

Страница: 51 / 72

Appendix
ProtoMat C30/C30-S 51
› After cleaning, the working depth limiter is reassembled in reverse
order and the motor is reinserted in the retaining block.
› Always check that the insertion depth of the spindle is correct before
starting up.
The distance between the drill tip and machine base plate must be 0.5
mm when the head is lowered.
The machine may not be able to drill through the board if the distance is
too great. A larger diameter should be used for the drill because a
smaller drill can easily break as it is being adjusted.
› Finally tighten the screws (2) back up and screw the collet lever (1)
back in (ProtoMat C30/S) .
fig. 33:
› Check the distance when reassembling the plotter spindle.
The machine may be damaged if the distance is too small when
drilling.
Caution! Use only graphite to lubricate the working depth limiter.
13.2 Lubricating the carriage guide wipers
You must make sure that the carriage guide wipers on the LPKF
ProtoMat C30 (C30/S)
are always well lubricated.
0.5mm