LiteOn EVO 8000 Series, Руководство пользователя

Страница: 5 / 169

2
1.1.4 Wiring

A control panel must have cooling fans, air vents and room for ventilation when the drive is installed
inside.

The mounting surface in contact with the heat sink should be made of metal, which provides good
thermal conductivity and prevents flammability

Please check the dust-proof and moisture-proof conditions to avoid the external environment
affecting the inverter function.
Caution

Allow only qualified electrical engineers to install the drive. Failure to comply could cause electrical
shocks to personnel or damage to the drive.

Ensure the power supply is off when connecting. Failure to comply could cause electrical shocks.

Ensure the ground terminal PE is properly wired. Failure to comply could cause electrical shocks from
the drive cover. Therefore ground the drive and motor for personnel safety.

Do not touch the main circuit terminal. Keep the main circuit off drive cover to avoid electrical
shocks.

The terminal for braking resistor is B1 and B2. Do not connect it to any other terminals. Failure to
comply could cause a fire.
Warning

Do not connect three-phase power supply to terminals U, V and W. Failure to comply could damage
the drive.

An output reactor is recommended when the cable connecting between the drive and motor is over
100 meters. Failure to comply could result in drive damage with overcurrent caused by
over-distributed capacitance.

Never connect the output terminals to capacitors or unapproved LC/RC filters. Failure to comply
could damage the drive components.

Separate the drive main circuit cables and control circuit cables. Failure to comply could cause
interference to the control signals

Ensure the phase of power supply and rated voltage match the label on the drive. Failure to comply
could drive damage.