FlexLine, 102
Applications
Next steps
1. Select the desired setup method.
2. For all methods except Resection, press
NewStn.
to enter new station
coordinates, or press
FIND
or
LIST
to select an existing point. For the Resection
method, the new station coordinates are calculated later.
3. For all methods except Ori. with Angle, press
OK
to continue to the
Enter target
data
screen. For the Ori. with Angle method,
OK
continues to the
MANUAL
ANGLE SETTING
screen. Refer to "9.2.2 Measuring the target points" , "MANUAL
ANGLE SETTING".
4.
Enter target data
: Enter the PtID of the target. Press
OK
to search for the point
in the internal memory. Select the desired point or enter new coodinates and
continue to the
Sight target point
screen. Refer to "9.2.2 Measuring the target
points", "Sight target point".
9.2.2
Measuring the target points
MANUAL ANGLE
SETTING
Available for
Method
:
Ori. with Angle
only.
Enter the PtID and height of the target. Measure the Hz angle and repeat the
measurement in face II if desired. Press Set to set the new orientation. The station
setup is complete.
Sight target point
The remaining screens are available for all methods except Ori. with Angle.
In the
Sight target point
screen:
2 / I:
Indicates that the second point was measured in face I.
2 / I II:
Indicates that the second point was measured in faces I and II.
