Leibinger JET3 up, Руководство по эксплуатации

Страница: 279 / 412

Group 8 Job Editor Page 277
JET3up Release R1.06
8.5.2.10 Meter Go function
The Meter Go function is a special function for printing length specifications on
cables, pipes etc. The function results from several parameter settings.
With these settings one can ensure that the meter counter carries on counting even
if there are no printouts. The counter works independent from the printout as long
as there are encoder signals.
External encoder signals are required for the position and speed measuring. In
addition there should be an external PrintGo signal provided in exactly the same
distance as the required printout of the length specifications (e.g. after each
meter).
It is not recommended to use the Meter-Go function with the internal PrintGo
signal.
To use the internal PrintGo signal you would have to specify the cable speed. Even
the smallest deviation would sum up with each printout and this would lead to a
significant deviation between the printed length specifications and the current
length of the cable.
Figure 153 Parameter settings Meter Go function
Counter object settings
Job settings
The crucial setting for the Meter Go
function within the parameters for the
counter object is the setting for the
<Counter Increment> . This value has
to be set to with PrintGo . Please see
example for details.
For printing length specifications on
cables, pipes etc. use the parameters
shown above. These settings are true
while using an external PrintGo signal.
Please see example for details.