Lantronix
ION x6010 User Guide
33493 Rev. F
Page 86 of 261
Displaying Information
There are several CLI commands that allow you to display (show) information about the NID
configuration. For a complete description of these and other CLI commands see “
Section 6: Command
Line Interface (CLI) Reference”.
Reset to Factory Defaults
If need be, you can reset all configurations in the IONMM back to their original factory defaults. This
operation can be accomplished through either the CLI or Web method.
IMPORTANT
This operation deletes
all
configuration information that was saved in the IONMM.
Resetting Defaults – CLI Method
1.
Access the NID through either a USB connection (see
“Starting a USB Session” 1
) or a Telnet session
(see
“Starting a Telnet Session”
).
2.
At the command prompt type:
reset factory
3.
Press
Enter
. The following displays:
Warning: this command will restart the specified card, connection will be lost!
C1|S18|L1D>
All configuration parameters will be reset to their factory values. For a list of all factory defaults, see
“Appendix B: Factory Defaults”
).
Note
: Your USB and/or Telnet session will be disconnected.
4.
Set the IP configuration (see
“Doing the Initial System Setup”
).
