Lantronix
ION x6010 User Guide
33493 Rev. F
Page 154 of 261
4 packets transmitted, 0 packets received, 100% packet loss
The attempted ping command failed. For example:
PING 192.168.1.10 (192.168.1.10): 56 data bytes
--- 192.168.1.10 ping statistics ---
4 packets transmitted, 0 packets received, 100% packet loss
1.
Verify the IP address.
2.
Check the cable connection.
3.
Refer to the
Ping
command section.
4.
Retry the command.
5.
If the problem persists, contact Technical Support.
Ping command can only be used on management card!
The attempted ping command was not accepted by the system. For example:
C1|S5|L1D>ping 192.168.1.30
Ping command can only be used on management card!
1.
Use the
go
command to switch to the IONMM card.
2.
Refer to the
Ping
command section.
3.
Retry the command.
4.
If the problem persists, contact Technical Support.
Only 100M fiber port can set far end fault!
The attempted far end fault command was not accepted by the system. For example:
C1|S16|L1P1>
set ether fef enable
Only 100M fiber port can set far end fault!
1.
Use the
go
command to switch to the 100M fiber port.
2.
Re-enter the
fef
command.
3.
Use an alternate Ethernet test command in place of the
fef
command.
4.
If the problem persists, contact Technical Support.
