Lantronix
ION x6010 User Guide
33493 Rev. F
Page 249 of 261
Appendix C Configuration Quick Reference – CLI
T1 Ports Configuration
1.
Access the x60xx through either a USB connection or a Telnet session.
2.
Configure the Port 1 Circuit ID.
Type
set circuit-ID=xx
.
3.
Configure the Port 1 Loopback Type.
Type
set tdm loopback type=phylayer
.
4.
Use the
go
command to switch to Port 2.
5.
Repeat steps 2-3 above to configure the Port 2 Circuit ID, AIS Transmit, and Loopback Type.
6.
Configure the Port 2 DMI function (optional - if supported).
7.
Click the
Save
button when done.
8.
Verify each port’s configuration.
Type
show tdm port config
.
Port Loopback Test –T1 and E1 Modes
1.
Place the x6010 in Hardware mode and set the x6010 front panel
CL
–
FL
switch to the
CL
position.
2.
Access the x6010 through either a USB connection or a Telnet session.
3.
Use the
go
command to switch to Port 1.
Type
go c1 sx l1p=1
and press
Enter
.
4.
Set the Port 1TDM Loopback type to PHY layer.
Type
set tdm loopback type=phylayer
and press
Enter
.
5.
Start the Port 1 Loopback operation.
Type
set tdm loopback oper=init
and press
Enter
.
6.
Stop the Port 1 Loopback operation.
Type
set tdm loopback oper=stop
and press
Enter
.
7.
Set the x6010 front panel
CL
–
FL
switch to the
FL
position.
8.
Use the
go
command to switch to Port 2.
9.
Repeat steps 4-6 for Port 2.
