Lantronix x6010, Руководство пользователя

Страница: 124 / 261

Lantronix ION x6010 User Guide
33493 Rev. F https://www.lantronix.com/ Page 124 of 261
Command :
Reset (Clear) All Ports Counters
Syntax : reset all ports counters
Description : Resets all counters on all ports of the specified Ethernet device. The device’s counters
(RMON statistics counters, dot3 counters etc.) are reset to zero and begin incrementing
immediately.
Example : C1|S5|L1D> reset all ports counters
C1|S5|L1D>
Command : List All Commands
Syntax : l
ist
<cr>
Description : Displays all of the available CLI commands.
Example :
C1|S2|L1D> list
go [c=<0-16>] [s=<0-32>] [l1ap=<1-15>] [l2ap=<1-15>] (l1p=<1-5>|l2p=<1-15>|l3p=<1-
15>|l1d|l2d|l3d)
home
list
prov get tftp svr addr
prov set tftp svr type=(ipv4|dns) addr=ADDR
quit
reboot
reset all ports counters
reset factory
reset uptime
set circuit-ID=CIRCUIT
set community read=COMMUNITY
set community write=COMMUNITY
set dbg level=<0-2>
set dmi rx-power-preset-level=POWER
set system name=NAME
set taos transmit=(enable|disable)
set tdm loopback oper=(init|stop)
set tdm loopback type=(noloopback|phylayer)
show card info
show cardtype
show circuit-ID
show dmi info
show firmware upgrade result
show firmware-db update result
show tdm config
show tdm loopback capability
show tdm loopback state
show tdm port config
stat
tftp get iptype=(ipv4|dns) ipaddr=ADDR remotefile=RFILE [localfile=LFILE]
tftp put iptype=(ipv4|dns) ipaddr=ADDR localfile=LFILE [remotefile=RFILE]
tftp upgrade iptype=(ipv4|dns) ipaddr=ADDR remotefile=RFILE
upgrade module
C1|S2|L1D>
Note that not all of the commands listed are necessarily operational on the x6010 models.