Labrie MINIMAX, Руководство по обслуживанию

Страница: 55 / 174

General Maintenance 47
The proximity switch light should turn on when the target is detected.
3.
Slightly close the tailgate a couple of inches.
As the target should not be detected by the proximity switch at such a position, the switch light
should be off.
4.
Repeat the procedure until the proximity switch is properly adjusted.
Adjusting Left-Hand Side Hopper Door Limit Switch (optional)
This limit switch (see Figure 3-29) turns off all hydraulic power when the left-hand side hopper door
is not closed. It also allows control of the crusher panel from inside the cab.
N
OTE
:
The left-hand side hopper door limit switch is found only on units equipped with an automated
arm.
N
OTE
:
In Ontario, provincial regulations require the use of this limit switch.
Figure 3-29 LHS hopper door limit switch
If installed, this limit switch is located on the inside hopper door frame.
To verify that the switch needs adjusting, open the LHS hopper door by approximately 2 inches
(5 cm) and try to operate any hydraulic function. No hydraulic function should be working.
To adjust the LHS hopper door limit switch:
1.
Unscrew the lever adjustement screws of the limit switch (see Figure 3-30).
2.
Raise or lower the detection lever a little bit and tighten up the screws.
3.
Test the operation.
The hydraulic system should be working when the LHS hopper door is closed.
Warning Injury or death may occur if you attempt to enter the body while the packer or arm is in
operation.