Labrie MINIMAX, Руководство по обслуживанию

Страница: 152 / 174

144 Multiplexing
This page contains a set of rectangles. Each of these rectangles is numbered and corresponds to a
specific function of the truck.
Colors are used to indicate whether the corresponding function is active or not:
Š
a blue rectangle means the corresponding function is inactive
Š
a green rectangle means the corresponding function is active
Also:
Š
a red rectangle means there is a closed short-circuit
Š
a yellow rectangle means there is an open circuit
A white-bordered rectangle means that this rectangle is selected. Use the directional arrows to select a
specific rectangle or function. When a rectangle is selected, a short description of the corresponding
function appears in the lower part of the screen.
After selecting a rectangle:
Š
press “ON” to activate the corresponding function (rectangle turns blue to green)
Š
press “OFF” to deactivate the corresponding function (rectangle turns green to blue)
Š
press “RESET” to have the software control the status of the corresponding function
N
OTE
:
To go from a module to another (e.g. from module 10 to 20), the operator has to go back to the
Module I/O Status page (see Figure 9-9) and select module 20.
Press “Esc” to return to the preceding page.
Joystick
The joystick page is accessible from the Module I/O Status page (see Figure 9-9). From that page
select “Joystick” using up/down arrows and press “OK”. The Joystick page opens (see Figure 9-16).
Figure 9-16 Joystick page
The Joystick page allows the operator to check if all functions of the joystick are working correctly. If
one joystick is installed on your vehicle, it will be represented on the display monitor by joystick
127.
However, if two joysticks are installed on your vehicle, any of the two joystick numbers (127 and 72)
can represent either joystick on the screen.