Labrie MINIMAX, Руководство по обслуживанию

Страница: 33 / 174

General Maintenance 25
Packer
The M
INIMAX
™ packer (see Figure 3-2) is submitted to intensive use during a work day (1000 to
3000 cycles). Therefore, some of its components have to be regularly looked at: the wear pads, which
are located at both sides of the packer and inserted in the body side rails, the follower panels, and the
rollers, which are also inserted in the body side rails (see Figure 3-3).
Labrie Enviroquip Group recommends that operators perform a daily visual inspection of the packer
and its components.
Hydraulic system Check oil level in tank,
and refill if necessary X See page 81
Check if the ball valve
on suction line is open X See page 73
Check on ground for
overnight leaks X
Check cylinders, pump,
control valve and
system for leaks. Repair
or replace if required X See page 73
Replace hydraulic filter
a
Twice a
year
See page 95
Clean strainer and refill X See page 92
Check pressure X See page 83
Hopper area Clean traps on each side X See page 23
Clean dirt around the
packer X See page 23
Visual inspection Rollers, hydraulic
cylinder and cylinder
pins, hoses, pipes and
connections, wear of
floor and hopper sides. X See page 25
Body and chassis Check for corrosion X
Keep the contact
surfaces clean between
the body and the
chassis. X
a. Also replace the return filter after the first 50 hours of use.
Component/System Verification Daily Weekly Monthly Yearly Page