Kyocera FS-6300, Руководство пользователя

Страница: 54 / 161

1.7. Memory Expansion Installation
1-32
Removing SIMMs
To remove a SIMM, carefully pull the end
catches slightly outwards and tilt the SIMM as
shown, then pull the SIMM out of the socket.
Reverse the procedure under Withdrawing the
Main Circuit Board from the Printer to put the
main circuit board back into the printer.
Testing the Expansion Memory
After you have finished installing SIMMs in the printer, test the printer to see if the instal-
lation has been successful.
To test the expansion memory, proceed as follows:
1.
Make sure the power switch is off. Plug the power cord into the printer and turn power
on.
2.
When the printer is on-line, press the STATUS key.
3.
If the installation has been successful, the Total memory (Memory Allocation) of the
status page will show the expanded memory size corresponding to the amount of mem-
ory added. (The factory installed memory size is 16 MB.)