Kyocera FS-6300, Руководство пользователя

Страница: 126 / 161

5.5. Indicators and Messages
5-13
0(025<&$5' HUUúú
3UHVV &217,18(
This message appears when an error occurs during access to the
memory card using the PRESCRIBE 2e RWER (ICCD) command or
from the printer's control panel. Look at the error code given in place
of
ýúú
and refer to the corresponding description given below. Note
that error codes of
ýíä
and above only result when memory card
operations are done fromthe control panel.
íì
: Data or memory card capacity is too large.
•This error code appears if an attempt is made to write more
than 32 MB of data to a memory card or if the capacity of the
memory card installed in the printeris more than 32 MB.
Decrease the data being written to the memory card to less
than 32 MB. Note that only the memory card of 32 MB and less
can be used by this printer.
•This error code appears when a data name not existing on the
memory card is specified. Check the data names on the mem-
ory card.
íë
: The memory card does not meet specifications. This memory
card cannot be used by this printer. Insert a memory card which
can be used by this printer. (See "Memory Card" of
Chapter 2 .)
íê
: The memory card is not a JEIDA card. Only a JEIDA Ver. 4.2
memory card can be used by this printer.
íé
: The card is an S-RAM or flash card which cannot be used by this
printer.
íè
: There is no battery in the memory card. Replace the battery in
the memory card with a new one.
íç
: The memory card is write-protected. Cancel the write-protec-
tion of the memory card.
íæ
: The memory card requires formatting. Format the memory
card from the control panel.
íä
: The capacity of the memory card is insufficient. This error code
appears when an attempt is made to write more data on the
memory card than available memory. To halt the writing of
data, first stop data transmissions from the computer, and then
the printer's
CONTINUE key. Press the FORM FEED key if the mes-
sage
ý:DLWLQJ
will appear in the message display. The mes-
sage display will return to reading
ý5HDG\
.
ìì
: The memory card is full of data items. The number of data items
which can be written on the memory card is limited to 127.
Pressing the
CONTINUE key will restore the message
ý5HDG\
in
the message display.
ìê
: This is a logical error. Try substituting another flash memory
card.
ìæ
: The flash memory card cannot be written due to insufficient
printer memory. Either delete unnecessary macros and/or fonts
stored in the printer, or expand the printer's available memory.
ìå
: This is a write error. Try substituting another flash memory
card. (Error codes
ýìê
through
ýìå
apply only to a flash memory
card.)
Message Corrective Action