Krone Big Pack 1270, Оригинальная инструкция по эксплуатации, Страница: 67 / 440

Initial operation 7
Adjusting the drawbar height 7.3
BiG Pack 1270
Original Operating Instructions 150000747_02_en 67
ü
The machine is not connected to the tractor.
„ For "Mechanical support jack" version: Raise/lower the support jack until the dimension
X=650–680 mm is measured between the pivot point (1) and the ground.
„
For "Hydraulic support jack" version: Reverse the tractor towards the drawbar until the
hydraulic hoses for the support jack can be connected.
„
Switch off the tractor engine, remove the ignition key and take it with you.
„
Connect the hydraulic hoses ( / ) on the machine to a double-acting control unit
on the tractor.
„
Using the double-acting control unit, raise/lower the support jack until the dimension
X=650–680 mm is measured between the pivot point (1) and the ground.
Determining the setting dimension ΔY for the drawbar eye
BEI000-237
„ To be able to determine the dimensions Y1 and Y2", carefully reverse the tractor against the
machine.
„
Determine dimension Y1, measured between the middle of the ball head drawbar eye and
ground.
„
Determine dimension Y2, measured between the middle of the ball head and ground.
Æ Dimension ΔY=Y1-Y2
„
Move the ball head drawbar eye of the large square baler by the dimension ΔY.