Krone Big Pack 1270, Оригинальная инструкция по эксплуатации, Страница: 307 / 440

Repairs, maintenance and settings by technicians 22
Setting MultiBale 22.2
BiG Pack 1270
Original Operating Instructions 150000747_02_en 307
22.2 Setting MultiBale
Checking/setting the position of the rear needle yoke
2
4
3 1
5
X
2
BP000-172
If the knotter gearbox is in idle position ( refer to page 53 ), the tube (2) of the rear needle yoke
(1) must be in the centre of the trough (3) of the needle brake (4).
Furthermore, the dimension must be X=11–18 mm , measured between the stop (5) and the
tube (2).
ü
The upper dead point of the knotter needle is checked and set, refer to page 305 .
ü The knotter gearbox is in the idle position, refer to page 53 .
„
Perform a visual check to ensure that the tube (2) is not in the centre of the trough (3).
Æ If the tube (2) is not in the centre of the trough (3), the rear needle yoke has been set
correctly.
Æ
Move the needle brake (4) if the tube (2) is not in the centre of the trough (3).
„ Check the dimension X.
Æ
If the dimension is X=11–18 mm , the stop (5) has been correctly set.
Æ
If the dimension is not X=11–18 mm , move the needle brake (4).
Repositioning the needle brake
6 5
4
1 2
X
3
BP000-173
ü
The knotter gearbox is in idle position, refer to page 53 .
„ Reposition the needle brake (3) in longitudinal direction in the hole pattern (4) until the tube
(1) of the rear needle yoke (6) is in the centre of the trough (5) of the needle brake (3).