Krone Big Pack 1270, Оригинальная инструкция по эксплуатации, Страница: 327 / 440

Repairs, maintenance and settings by technicians 22
Setting the plunger 22.14
BiG Pack 1270
Original Operating Instructions 150000747_02_en 327
BPG000-042
• The bale channel is equipped with 2 counterblades.
• The plunger (1) is equipped with 7 blades.
ü
The machine is shut down and safeguarded, refer to page 27 .
„ Trigger the tying process manually with machine at standstill, refer to page 112 .
„
Release flywheel brake, refer to page 92 .
„ Turn the flywheel manually in working direction until the blades (2) are positioned above the
counterblade (3),
refer to page 113 .
„
Apply flywheel brake refer to page 92 .
„ Check the dimension X between blade (2) and counterblade (3).
Æ
If the dimension is X=2-4 mm , the setting is correct.
Æ If the dimension is not X=2-4mm , the plunger must be raised or lowered via the eccentric
rolls.
Setting the eccentric roll
BPG000-043
„ Loosen the counter nut (4).
„
Loosen the clamping screw (3).
„ Raise or lower plunger via eccentric rolls until dimension is X=2-4 mm .
„
Make sure that all four rolls support equally.
„ Tighten the counter nut (4), tightening torque = 45 Nm.
„
Tighten the clamping screw (3), tightening torque = 160 Nm.