Krone Big Pack 1270, Оригинальная инструкция по эксплуатации, Страница: 28 / 440

2 Safety
2.6 Safety labels on the machine
28
BiG Pack 1270
Original Operating Instructions 150000747_02_en
2.5.3 Carrying out oil level check and oil and filter element changes safely
WARNING
Carrying out oil level check and oil and filter element changes safely
If oil level check and oil and filter element changes are not carried out safely, the operational
safety of the machine may be impaired. This may result in accidents.
„ Carry out oil level check and oil and filter element changes safely.
To carry out oil level check, oil and filter element changes safely:
„ Lower raised machine parts or secure them against falling, refer to page 27 .
„
Shut down and safeguard the machine, refer to page 27 .
„ Observe the intervals for oil level check, oil and filter element changes, refer to page 201 .
„
Use only the oil grades and quantities specified in the consumables table, refer to page 60 .
„ Clean the area around the parts (for example gearbox, high-pressure filter) and make sure
that no foreign objects get into the parts or the hydraulic system.
„
Check existing seal rings for damage and replace them, if necessary.
„ Collect leaking or waste oil in a container designated for the purpose and dispose of it
properly,
refer to page 22 .
2.5.4 Running actuator test
WARNING
Run actuator test safely
When actuators are energised, functions are carried out directly and without a safety prompt.
This may cause the unintentional movement of machine parts, trapping and seriously or
fatally injuring persons.
ü
Only persons familiar with the machine are permitted to perform the actuator test.
ü The person performing the test must know which machine parts are activated by
controlling the actuators.
„
Run the actuator test safely.
To run the actuator test safely:
„ Lower raised machine parts or secure them against falling, refer to page 27 .
„
Shut down and secure the machine, refer to page 27 .
„
Cordon off the danger zone of the actuated moving machine parts in a clearly visible
manner.
„
Ensure that there is nobody in the danger zone of the actuated moving machine parts.
„
Switch on the ignition.
„
The actuator test must only be performed from a safe position outside the area that is
affected by machine parts moved by the actuators.
2.6 Safety labels on the machine
Every safety label is provided with an order number and can be ordered directly from the
authorised KRONE dealer. Immediately replace missing, damaged and unrecognisable safety
labels.