![background image](http://html.mh-extra.com/html/kramer/k-config/k-config_user-manual_2002034104.webp)
K-CONFIG –
Assigning the Controlled Devices to Master and Auxiliary Device Ports
97
7
Assigning the Controlled Devices to Master and Auxiliary Device Ports
You are here:
Configuration Steps
Description
Section
Introduction
General information and system requirements
Planning
Carefully plan your controlled room
Installation
Install the Software
Introduction to K-Config
Get to know the K-Config main window, menus and quick access icons
Driver Manager
Define the Controlled Device Drivers
Project Navigator
Define the Controlled Room
Port Manager
Assign the controlled devices to the Master and Auxiliary device ports
Triggers
Activate the Triggers
Adding Actions
Describes how to add the various actions to a trigger
Connecting to a Device
Describes how to connect to a device, upgrade the firmware, read/write to the device
and so on
Using the Web pages
Describes how to control the device via the Ethernet and perform minor configuration
operations
Creating a Virtual Master
Describes how to create a Virtual Master to control a room via KRAMER NETWORK
The Port Manager window lists the ports on the selected room controller device (Master room controller or Auxiliary
device) or standalone room controller for assigning controlled devices to its ports. It enables writing a description for
the assigned device and assigning a default driver to each port.
Note that ports on auxiliary devices can be used only for sending outgoing commands from the auxiliary
device to an AV controlled device. If you need device responses to use Monitor Event triggers or Queries
functions, which rely on bidirectional communication, connect the AV controlled device to the K-NET master
room controller device. For similar reasons, GPI/O ports on the auxiliary devices will be disabled.
In the following example, the project navigator includes the
RC-74DL
, the
RC-63DL
, the
RC-53DLC
and the
SL-10
,
Figure 179: The Control Room Example
To set the ports of the Master device (for example, RC-74DL)
:
1.
Select 1-RC-74DL in the
Project Navigator
area.
2.
In the
Windows
menu, select
Port Manager
.