Kramer K-CONFIG, Руководство пользователя, Страница: 104 / 188

K-CONFIG – Assigning the Controlled Devices to Master and Auxiliary Device Ports 97
7 Assigning the Controlled Devices to Master and Auxiliary Device Ports
You are here:
Configuration Steps Description Section
Introduction General information and system requirements 1
Planning Carefully plan your controlled room 2
Installation Install the Software 3
Introduction to K-Config Get to know the K-Config main window, menus and quick access icons 4
Driver Manager Define the Controlled Device Drivers 5
Project Navigator Define the Controlled Room 6
Port Manager Assign the controlled devices to the Master and Auxiliary device ports 7
Triggers Activate the Triggers 8
Adding Actions Describes how to add the various actions to a trigger 9
Connecting to a Device Describes how to connect to a device, upgrade the firmware, read/write to the device
and so on 10
Using the Web pages Describes how to control the device via the Ethernet and perform minor configuration
operations 11
Creating a Virtual Master Describes how to create a Virtual Master to control a room via KRAMER NETWORK 12
The Port Manager window lists the ports on the selected room controller device (Master room controller or Auxiliary
device) or standalone room controller for assigning controlled devices to its ports. It enables writing a description for
the assigned device and assigning a default driver to each port.
Note that ports on auxiliary devices can be used only for sending outgoing commands from the auxiliary
device to an AV controlled device. If you need device responses to use Monitor Event triggers or Queries
functions, which rely on bidirectional communication, connect the AV controlled device to the K-NET master
room controller device. For similar reasons, GPI/O ports on the auxiliary devices will be disabled.
In the following example, the project navigator includes the RC-74DL , the RC-63DL , the RC-53DLC and the SL-10 ,
see Figure 179 .
Figure 179: The Control Room Example
To set the ports of the Master device (for example, RC-74DL) :
1. Select 1-RC-74DL in the Project Navigator area.
2. In the Windows menu, select Port Manager .