Korg iS35, Руководство пользователя

Страница: 11 / 249

Getting Started • Introduction
3
Connecting the iS35 to a hi-fi system
Connect the OUTPUT jacks of the iS35 to the AUX or
TAPE inputs of the amplifier using two audio cables
with a mono jack at one end and an RCA connector at
the other end (do not use the PHONE or TUNER
inputs).
Connecting the power cable
●
Plug the power cable into
the power socket.
Make sure that the mains
voltage is suitable for the
instrument (the voltage is
indicated next to the AC
power inlet).
Turning on the power
●
Press the
POWER switch
to turn the
instrument on.
On turning on,
the instrument
will be in the
Arrangement
Play mode. If you are connected to an external
amplifying system, turn the speakers on only after
having switched on the iS35.
●
To turn the instrument off, press the POWER
switch again.
In order to save on electricity, turn the instrument
off when you are not using it. Do not turn the
power off while the disk indicator is lit or while a
message such as “Loading”, “Saving” or “Format-
ting” is shown on the LCD display.
Note:
When the instrument is turned off, all the data
contained in the RAM memory will be lost (e.g. back-
ing sequence and song). On the contrary, USER styles,
USER arrangements and USER programs are
retained. Before turning the instrument off, save back-
ing sequence (
☞ P. 40) and song ( ☞ P. 42) on disk.
Adjusting the general volume
●
Use the MASTER VOLUME sli-
der to adjust the general
volume of the internal sound
generation.
Moving the slider upward
towards “10” will increase the
volume and moving it downward
towards “0” will decrease the
volume. In the “0” position the instrument will be
mute.
If you are connected to an external amplifying sys-
tem, you should at this point turn the volume of the
mixer or the speakers up and then adjust both the
volume of the iS35 and that of the speakers.
The MASTER VOLUME slider controls the volume
of the speakers, the headphones and the OUTPUT
jacks located on the rear panel.
Note:
The slider does not control the volume of the
VOCAL/GUITAR section (signal coming from the
INPUT-IN connector). To adjust the level of the section
use the VOLUME slider of the VOCAL/GUITAR sec-
tion. Use the GAIN slider (located on the back of the
instrument) to adjust the input gain.
Warning: At the maximum volume the sound can be
distorted. Should this happen, decrease the volume of
the iS35.
Adjusting the volume of the
Vocal/Guitar section and the
audio input (Input-In)
The VOCAL/GUITAR section takes the input signal
from the INPUT-IN connector and process it with ded-
icated effects. The processed signal is added to the
sounds produced by the internal sound generation
and comes out of the built-in speakers and the OUT-
PUT jacks.
●
Use the VOLUME knob (in the
VOCAL/GUITAR section) to
adjust the level of the section.
Rotating the knob towards “10”
will increase the volume, and rota-
ting it towards “0” will decrease the volume. In the
R L/MONO
OUTPUT