Korenix Technology Co., Ltd.
Industrial
Layer 3 Managed Ethernet Switch
_____________________________________________________________________________
Industrial Layer 3 Managed Ethernet SwitchUser Manual
Page: 809/1246
9.2.3.7
TraceRoute Function
Use this screen to tell the switch to send a TraceRoute request to a specified IP address.You can use
this to discover the paths packets take to a remote destination. Once you click the Submit button, the
switch will send traceroute and the results will be displayed below the configurable data. If a reply to the
traceroute is you will see
1 x.y.z.w 9869 usec 9775 usec 10584 usec
2 0.0.0.0 0 usec * 0 usec * 0 usec *
3 0.0.0.0 0 usec * 0 usec * 0 usec *
Hop Count = w Last TTL = z Test attempt = x Test Success = y.
Configurable Data
Host Name/IP Address Address Type
- Select the address type for IPv4 Address or Host Name.
IPv4
- Select the way "IPv4 Address" to trace.
IPv4
DNS
- Select the way "host name" to trace.
IPv6
DNS
- Select the way "Host Name V6" to trace.
IPv6
- Select the way "IPv6 Address" to trace.
IP Address/Hostname
– Enter the IP address or Hostname of the station you want the switch to
discover path. The initial value is blank. Hostnames are composed of series of labels concatenated
with dots. Each label must be between 1 and 63 characters long, and the entire hostname has a
maximum of 255 characters. The IP Address or Hostname you enter is not retained across a power
cycle.
Probes Per Hop
- Enter the number of probes per hop. The initial value is default. The Probes per
Hop you enter is not retained across a power cycle.
MaxTTL
- Enter the maximum TTL for the destination. The initial value is default value. The MaxTTL
you enter is not retained across a power cycle.
InitTTL
- Enter the initial TTL to be used. The initial value is default value. The InitTTL you enter is
not retained across a power cycle.
MaxFail
- Enter the maximum Failures allowed in the session. The initial value is default value. The
MaxFail you enter is not retained across a power cycle.
Interval
- Enter the Time between probes in seconds. The initial value is default value. The Interval
you enter is not retained across a power cycle.
