Konica Minolta CS-7, Руководство по эксплуатации

Страница: 103 / 424

103
Chapter 5
5.3 Exposure with DR Detector (Aero Sync mode)
IMPORTANT •••••••••••••••••••••••••••••••••••••
• When the "Ready" is displayed, immediately perform
exposure.
• Do not let the DR Detector vibrate or receive shock
until the exposed image is displayed.
• If image acquisition started without performing ex -
posure, this may result in incorrect detection due to
noise, etc . Perform rejecting (image deletion) and re-
peat exposure.
• If image acquisition does not start after exposure, the
voltage may not be enough. Check the exposure con
-
ditions and repeat exposure.
• When exposure is done while "Ready" is not dis -
played, have an interval of 1 minute or more before
repeating exposure.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
z
When the [AeroSync Button] is ON
1
Prepare the DR Detector.
• A message "Waiting for permission" is displayed
in the image display area .
HINT •••••••••••••••••••••••••••••••••••••
• If the information about the body part is not imported
while importing examination information from the high -
er system, select the body part to be imaged . Then
press [Perform] on the body part selection screen to
display the exposure screen.
• When the AeroDR power management level is set to
[3], [4] or [5], "Waiting to start shooting" is displayed
instead of "Waiting for permission" .
•••••••••••••••••••••••••••••••••••••••••••••••••••••
IMPORTANT •••••••••••••••••••••••••••••••••••••
• A malfunction may be caused by a shock to the DR
Detector. In such cases, set [AeroSync Button] to ON
on the system monitor screen .
• To prevent incorrect operations, always check that
"Ready" is displayed .
• Conditions for changing the detection level vary de-
pending on the X-ray device being used . If a survey
has been carried out when the system was installed,
follow the survey results .
• When using the AeroDR 3 1417HD, click the modal-
ity icon before making an exposure and select the
AeroDR 3 1417HD .
•••••••••••••••••••••••••••••••••••••••••••••••••••••
HINT •••••••••••••••••••••••••••••••••••••
• The X-ray detection level can be set when making an
exposure. Refer to "5.3 Exposure with DR Detector
(Aero Sync mode)" for information on the X-ray detec-
tion levels that can be set .
• When importing examination information from the
higher system and when exposure body part informa
-
tion is not imported, select the exposure body part.
When pressing [Perform] on the body part selection
screen, the exposure screen is displayed.
• When you move the focus in the image display area
on the exposure resumption waiting screen to cap -
ture an image of another body part, not the ready-to-
expose screen but the exposure resumption waiting
screen is displayed .
•••••••••••••••••••••••••••••••••••••••••••••••••••••
2
Perform exposure .
• Configure the X-ray device settings and check
the exposure setting before making an expo -
sure .
Press the exposure switch
• As soon as the exposed image is transferred,
the image is displayed in the image display area .