Kikusui PCZ1000A, Руководство по эксплуатации

Страница: 60 / 100

3-26
PCZ1000A
10
Use the rotary knob to select the number of parallel units.
Up to five units (including the master) can be connected together for parallel
operation. The current will not display correctly on the master unit if the actual number
of units is different to the number specified here. Always take care to specify the actual
number of connecting units. The following example is for two units.
11
Press the ENTER key displays ">4: Calibration". If you do not want to
calibrate the total current on the master unit, press the SHIFT + I SET
(CONFIG) key or the ESC key to exit CONFIG setting.
When parallel operation is set, the number of units connected in parallel is displayed
on the bottom left of the front panel display. The example below is for the case when
two units are connected.
• Although the set ranges for the current, power, and resistance are all increased on
the master unit, the pre-setup values still appear on the display. When you carry
out parallel operation by a mode except CP mode, be sure to change PSET value
of the master unit to the required power value.
> 3: Parallel Ope.
2
0.00Ar 0.0Ap 100.1V
2 ISET 0.00A --