Kikusui PCZ1000A, Руководство по эксплуатации

Страница: 51 / 100

PCZ1000A
3-17
3
Ope
ration
6
Press the LOAD key to change to the load-on state.
The LED above the LOAD key illuminates. "CREST FACTOR" appears in the lower
part of the display to indicate that the Crest Factor function is operating.
At this time, the RMS current from the equipment under test can be changed by
pressing the I SET key to change the current limit value while leaving the crest factor
unchanged (remains set to 2.0 in this example). Similarly, the C.F key can be pressed
again to change the crest factor setting.
7
Press the SHIFT + C.F key again to end the crest factor function.
• Changing the crest factor setting does not change the current limit value. In other
words, this can be used to change the peak current value only while leaving the
RMS value of the current unchanged.
• The crest factor function can only be used in CC mode.
3.6 Saving and Recalling Preset Memory
Three preset memories (A, B, and C) are available in each mode and can be used to
save and recall the following settings. DMEM key allows you to change only the
limit values and the ranges stored in memory, retaining the current limit values.
Crest factors cannot be modified using the DMEM key.
CC mode Current limit, CF function (crest factor setting)
CR mode Resistance limit, range setting
CP mode Power limit
7.00Ar14.0Ap 95.0V
--CREST FACTOR 2.0--
8.00Ar11.3Ap 95.0V
-- ISET 8.00A --