Kikusui PCZ1000A, Руководство по эксплуатации

Страница: 47 / 100

PCZ1000A
3-13
3
Ope
ration
3
Press the R SET key to enable CR mode.
The LED above the R SET key illuminates.
4
Turn the rotary knob quickly clockwise to set the resistance limit value
approximately.
5
Turn the rotary knob slowly clockwise to set the exact value.
6
Press the LOAD key to change to the load-on state.
The LED above the LOAD key illuminates and current flow starts.
7
Use the rotary knob to set the resistance limit value.
Changing the resistance limit value during load-on also changes the current. In this
example, the current value displayed at the top left changes to 9.51 A as a result of
changing the resistance limit value to 8.928 5
Ω
.
8
Use the SHIFT + R SET (RANGE) key to change the range.
As this example changes to the L range, the resistance is limited to the minimum value
for the L range (9.000 0
Ω
in this example) and so the current reduces. It is not possible
to set the resistance limit to less than the minimum value.
If the resistance limit value is within the region where the H and L ranges overlap
(9.000 0
Ω
to 1 000.0
Ω
), the resistance limit value remains unchanged when the range
is switched.
However, because the setting resolution is different in the two ranges, the setting
changes to the next highest resistance value for the new range.
0.00Ar 0.0Ap 85.0V
-- RSET 1000.0
· H--
0.00Ar 0.0Ap 85.0V
-- RSET 11.905
· H--
0.00Ar 0.0Ap 85.0V
-- RSET 10.000
·
H--
8.49Ar12.0Ap 84.9V
-- RSET 10.000
· H--
9.51Ar 13.5Ap 84.9V
-- RSET 8.9285
· H--
9.43Ar 13.3Ap 84.9V
-- RSET 9.0000
· L--