KEPCO BOP 1000W, Руководство оператора

Страница: 97 / 188

BOP HIPWR 080709
3-33
When all settings are complete, press
$
to save for power-up. This step create a repeating
1/4 sine wave that starts at 6V and rises to 10V over 5 ms (1/4 of 20ms period established
by 50Hz frequency). The waveform shown in Figure 3-11 has now been saved. Note that by
careful calculation of period and start/stop angle, accurate waveform simulations can be
attained.
7. Either execute the completed waveform by pressing STANDBY (to turn the output on), then
$
, or press
%
to return to the Saved Waveforms screen.
3.3.9.10 COPYING A WAVEFORM
After observing the precautions of PAR. 3.3.9.1, press
@
from the power-up screen to enter
the Saved Waveforms screen (Figure 3-9). Highlight one of the stored waveforms, then press
$
. Then highlight a waveform location designated Empty and press
$
to save or
%
to abort
the change and exit. The copied waveform may then be modified and saved with a new name if
desired (see PAR. 3.3.9.7).
3.3.10 RESET
CAUTION: PRESSING RESET WILL CAUSE VOLTAGE TRANSIENTS TO APPEAR AT
THE OUTPUT WHICH MAY DAMAGE A CONNECTED LOAD. SWITCH IS
RECESSED TO PREVENT INADVERTENT ACTIVATION.
Pressing RESET causes the power supply to execute a complete power on sequence to reset
the power supply to the power up settings (see PAR. 3.3.7).
3.3.11 OPERATOR TESTING
The Test System submenu is entered by pressing
%
from the power-up screen, then highlight
Revision/Test and press
!
. Upon power-up all tests are flagged as Untested . Table 3-14 lists
the tests that can be run. Highlight the choice and press
#
to run the selected test.
3.3.12 ERROR MESSAGE EXPLANATIONS
When a key press is not accepted, an error message is displayed at the bottom of the screen.
Although recovery from most operator errors is obvious and simple, Table 3-13 lists all the error
messages along with associated explanations as to why they occurred.
TABLE 3-13. ERROR MESSAGE EXPLANATIONS
ERROR MESSAGE EXPLANATION
General
Multiple Decimal places not supported Decimal key was pressed while to the right of the existing decimal point.
Exceeding Maximum Allowed Value To check maximums, go to power-up screen, press
%
, highlight Max/Min Settings, press
!
.
Sign does not affect Protection Limits Protection Limit field is positive or negative, numerical value does not need sign
Entry incomplete, Depress ENTER
key When changing either the main channel or the protect channel, using the number keys, the
change must be applied to the output by pressing
ENTER before moving on to change the
other channel.
Executing List A waveform is currently executing via remote mode. Commands to change the output are
not accepted until list is stopped (send command VOLT:MODE FIXED).