KEPCO BOP 1000W, Руководство оператора

Страница: 78 / 188

3-14
BOP HIPWR 080709
Press
%
from the power-up screen to enter the General Setup menu (Figure 3-6), then high-
light Max/Min Settings. Press
!
to enter the Max/Min Settings submenu (Figure 3-7). (If a
Password is required, see PAR. 3.2.4.4 for instructions.) Highlight Protect Entry and press
!
to
change it. Highlight Bipolar or Independent, then
$
to save, or
%
to abort. When complete,
press
$
to save for power-up, or
#
to abort, or
%
to apply the changes (without saving for
power-up) and exit.
FIGURE 3-6. GENERAL SETUP MENU
Minimum (box)
+Voltage Protect Min
–Voltage Protect Max Current mode only. Minimum (positive) setting for +Voltage Protect and
maximum (maximum negative) setting for –Voltage Protect. Values of ±Volt-
age Protect bVoltage Protect Min and –Voltage Protect Max (near
zero) are not allowed. This zone (also referred to as the
minimum (box) is
automatically calculated by the BOP (see Figure 1-3).
N/A N/A
+Current
–Current Current mode only. Positive and negative output current established by
keypad or remote command.
Range (+): 0 to +Current max
Range (–): 0 to –Current min
3.3.3 B.17
+Current max
–Current min Current mode only. Maximum (positive) and minimum (maximum
negative) current that can be set.
Value (+): 0 to +I
Onom
Value (–): 0 to –I
Onom
3.3.4.1 B.19, B.20,
B.23, B.21
TABLE 3-4. VOLTAGE AND CURRENT PARAMETER DEFINITIONS (CONTINUED)
Term Definition
To modify
refer to PAR.
Local Remote