Kathrein UFS 923, Руководство по эксплуатации

Страница: 95 / 148

95
Main menu - Channel search
Search with Service ID
After calling up the menu, you will see the
following on-screen display:
The

buttons allow you to select
the parameters you want to change for the
search.
Satellite and position
Use the

buttons to select the satellite that is transmitting the channels to be searched. By pressing
the

button at this point, you can view a list of the installed satellites. Use the

buttons to select the
satellite you want and con fi rm your selection with the

button. Make sure your receiver is aligned to this/
these satellite(s).
Transponder frequency
Use the

buttons (transponder frequency already stored) or the number pad (transponder frequency
not yet stored) to select the transponder frequency on which the channel being sought is transmitted. By
pressing the

button at this point, you can view a list of the transponders stored for the selected satellite.
Use the

buttons to select the transponder you want and con fi rm your selection with the

button. At
the bottom right of the screen display, the receiver will show the current signal strength and signal quality of
the selected transponder.
The “DVB Type”, “FEC”, “Polarisation” and “Symbol Rate” options only need to be speci fi ed if the
transponder has yet to be stored.
DVB type
Press the

buttons to select whether you want to search for standard channels (DVB-S (SD)) or for
HDTV channels (DVB-S2 (HDTV)).
Error rate
Press the

buttons to select the applicable error rate (Viterbi rate). When searching for DVB S(SD)
transponders, you need not state the error rate. “Automatic” will appear permanently instead. When search-
ing for DVB S2(HD) transponders, you must state the correct error rate. Either QPSK 1/2, 2/3, 3/4, 3/5, 4/5,
5/6, 8/9, 9/10 or 8PSK 2/3, 3/4, 3/5, 5/6, 8/9 or 9/10.