
Full Digital Color Doppler Ultrasonic Diagnostic Instrument (Vet) User’s Manual V1.00
- 18 -
Chapter Nine Select probe and application mode
This system is built-in a variety of application modes, the application modes are different according to
the different probes, user can select as required. The system supports the following application modes:
abdomen, obstetric, cardiac, urogly, superficial and user-defined.
9.1 Select probe and application mode
1. Press
key to pop up “Probe Selection” interface;
2. Select the corresponding probe picture, the picture is automatically hightlighted, press
『
Set
』
key to
save and exit;
3. Press
key to exit the current interface without saving probe.
9.2 User Settings
System default parameter information
1. Press
key to pop up “Probe Selection” interface;
2. Select the “SYSTEM” button in the User Setting, press
『
Set
』
key, and then move the cursor to select
the corresponding probe picture, the instrument will show the system default paramenter
information;
3. Press
key to enter System Preset menu, move the cursor to select
『
Param Display
』
, press
『
Set
』
key, the screen pops up “System default parameter display” interface, it shows the default values of
system, press
「
Cancel
」
to exit the system default parameter display interface.
User-defined parameter information
System has default parameter settings. If does not satisfied with the default parameters, user can
adjust them as needed. To avoid adjusting repeatedly each time, user can set the adjusted parameter
settings as their own specific parameters, namely using a custom function; doing so ensure that you can
directly enter into your desired parameters at next boot. Specific operation is as follows:
1. Press
key to pop up “Probe Selection” interface;
2. In the “USER1”, “USER2”, “USER3” or “USER4” buttons of User Setting, select one user-defined
button, such as select “USER3” button, press
『
Set
』
key, and then move the cursor to select the
corresponding probe picture, the system will enter work interface;
3. In the inspection process, user adjusts the various parameters according to the need. After completed
the adjustment of parameters;
4. Press
key to enter System Preset menu, move the cursor to select
『
Param Display
』
, press
『
Set
』
key, the screen pops up “User3 parameter display” interface, the parameters in this interface are the
regulated parameters that system automatically remembered user setting;
5. If choose
「
Saved to user
」
button, press
『
Set
』
key to saved to User3 and exit the User3 parameter
display interface; if choose
「
Return to default
」
button, press
『
Set
』
key, it will restore to default vaules
of system and exit this interface; if choose
「
Cancel
」
, press
『
Set
』
key to give up user setting.
Attention:
When the markers of measurement and calculation, text comments are being
used, if you switch the application mode, the markers of measured data, text comments and
arrows on the image will be cleared, measured data will not be saved.