Juniper JUNOSE 11.3, Руководство по настройке

Страница: 83 / 632

14 -- -- 0
15 superUser 10 14 0 1 2 3 4 5 6 10 14 15
*Privilege Group can reach itself
Example 12 shows privilege group overrides in effect.
Example 13
host1# show privilege group 15 superUser
The following groups are directly reachable:
14
dailyAdmin
The following groups are reachable:
1
14
2
3
4
basicUser
dailyAdmin
dailyTroll
minUser
In Example 13, groups 14 and dailyAdmin are directly reachable and groups 1, 14, 2, 3, 4,
basicUser, dailyAdmin, dailyTroll, and minUser are reachable.
privilege
•
Use to change the privilege level of any command within a specified mode.
•
Example 1
host1(config)# privilege exec level 12 terminal width
•
Example 2
host1(config)# privilege exec all level 5 terminal
•
Use the all keyword to change the privilege level of groups of commands. For more
information, see “Setting Privilege Levels for Multiple Commands” on page 56.
•
Use the reset version to restore the default privilege level for the command; issuing
this command results in the show configuration command not showing the default
privilege setting for the command.
•
Use the no version to restore the default privilege level for the command; issuing this
command results in the show configuration command showing the default privilege
level of the command in its output.
NOTE: You must access the CLI at privilege level 15 to view or use this
command.
•
See privilege
privilege-group alias
53 Copyright © 2010, Juniper Networks, Inc.
Chapter 2: Command-Line Interface