Juniper JUNOSE 11.3, Руководство по настройке

Страница: 403 / 632

synchronize
•
Use to force the NVS file system of the redundant SRP module to synchronize with
the NVS file system of the primary SRP module.
•
If you synchronize the redundant SRP module with the primary SRP module and the
redundant module is armed with a release different from the one it is currently running,
the redundant SRP module is automatically rebooted to load the armed release.
•
Optionally, you can use the low-level-check keyword to force the router to validate
all files or only configuration files in NVS, and to synchronize all files that failed the
checksum validation test during the
flash-disk-compare command as well as any
other files that are unsynchronized.
•
When you use the low-level-check keyword, you must also specify one of the following
keywords:
•
all —Validates all files in NVS, and synchronizes all files that failed the checksum
test as well as any other unsynchronized files; this option can take several minutes
to complete.
•
configuration —Validates all configuration files in NVS, and synchronizes all files
that failed the checksum test as well as any other unsynchronized files; this option
takes less time to complete because it validates only a subset of the files in the NVS
file system.
•
If one or more of the following conditions exist when you use the low-level-check
keyword, the command fails and the router displays a message that explains why it
cannot perform the synchronization:
•
The router does not contain a redundant SRP module.
•
The redundant SRP module is offline.
•
The armed releases are different on the primary SRP and redundant SRP.
•
Examples
host1# synchronize
host1# synchronize low-level-check all
host1# synchronize low-level-check configuration
•
There is no no version.
•
See synchronize.
Reformatting the Primary Flash Card
You can reformat the primary flash card. To do so:
1.
Access Boot mode.
a. From Privileged Exec mode, enter the reload command. Information about the
reloading process is displayed.
b. When the countdown begins, press the mb key sequence (case-insensitive).
373 Copyright © 2010, Juniper Networks, Inc.
Chapter 6: Managing Modules