Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010, Справочник по командам

Страница: 918 / 1506

ip nat pool
Syntax
ip nat pool name [ startIpAddress endIpAddress ]
{ netmask networkMask | prefix-length length }
no ip nat pool name
Release Information
Command introduced before JUNOSe Release 7.1.0.
Description
Creates an address pool from which the NAT router obtains an address when
performing a dynamic translation. You can create address pools with either a single
range or multiple, nonoverlapping ranges. The
no version removes the NAT pool.
NOTE: The router will not allow you to remove a pool that has allocations outstanding.
Before removing this type of pool, you must remove the dynamic translation, clear
any outstanding translations, and then remove the pool.
CAUTION: Specifying a range in “single line” mode from the CLI replaces all other
ranges. You cannot specify a range in this mode if any existing ranges are in use. To
add additional ranges, issue this command to access IP NAT Pool Configuration
mode.
Options
■
name —Name of the address pool; 32 alphanumeric characters maximum
■
startIpAddress —First IP address (inclusive) in the NAT pool range you are creating;
omitting this value in the command (along with endIpAddress ) launches the IP
NAT Pool Configuration mode, in which you can enter multiple, discontinuous
ranges
■
endIpAddress —Last IP address (inclusive) in the NAT pool range you are creating;
omitting this value in the command (along with startIpAddress ) accesses IP NAT
Pool Configuration mode, in which you can enter multiple, discontinuous ranges
■
ipAddressMask— Subnet mask for any NAT pool ranges you specify
■
length —Length of the network prefix; the number of bits masking the base
address that results in the address that you want to match
Mode
Global Configuration
876 ■
ip nat pool
JUNOSe 11.1.x Command Reference Guide A to M