Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010, Справочник по командам

Страница: 1459 / 1506

mpls signaling-interface
Syntax
mpls signaling-interface interfaceType interfaceSpecifier
no mpls signaling-interface
Release Information
Command introduced in JUNOSe Release 7.1.0.
Description
Specifies a particular layer 2 interface as the signaling interface for an MPLS major
interface that is stacked on an ATM AAL5 interface. MPLS uses the IPv4 or IPv6
interface stacked on the specified interface for signaling. The
no version restores the
default behavior, wherein MPLS nondeterministically selects a layer 2 interface as
the signaling interface.
NOTE: You can configure this command only for interfaces that use the interface
label space. For interfaces that use the platform label space, the signaling interface
is always next to the MPLS major interface, that is, stacked on the same lower
interface and is not configurable.
Options
interfaceType —Interface type; see Interface Types and Specifiers on page 5
■
■
interfaceSpecifier— Particular interface; format varies according to interface type;
see Interface Types and Specifiers on page 5
Mode
Interface Configuration
mpls signaling-interface
■ 1417
Chapter 13: M Commands