Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010, Справочник по командам

Страница: 1023 / 1506

ip vrrp icr-partition svlan-list explicit
Syntax
ip vrrp vrid icr-partition svlan-list-explicit [ svlanIdValue vlanIdValue ] *
[ use-default-mac ] [ control-interface ] [ advertise-mac ]
no ip vrrp vrid icr-partition svlan-list-explicit [ svlanIdValue vlanIdValue ] *
Release Information
Command introduced in JUNOSe Release 10.3.0.
Description
Adds an S-VLAN range and VLAN range to the ICR partition. You can assign only
unique S-VLAN range and VLAN range to the partition. If you attempt to assign a
previously assigned S-VLAN range and VLAN range to the ICR partition, the router
displays an error message. You can assign S-VLAN range and VLAN range only if you
have selected S-VLAN based grouping by using the
ip vrrp icr-partition group
command. The no version deletes the S-VLAN range and VLAN range from the ICR
partition.
NOTE: You can use the listed optional parameters only when you add a S-VLAN,
VLAN pair to the ICR partition. You cannot modify an existing subinterface using
these parameters. You can specify the optional parameters in any order.
Options
■
vrid —VRID identifier; a number in the range 1–255
■
svlanIdValue —S-VLAN identifier; a number in the range 0–4095
■
vlanIdValue —VLAN identifier; a number in the range 0–4095
■
use-default-mac —Configures the S-VLAN range and VLAN range to use the
default MAC address. By default, the router assigns the VRRP media access
control (MAC) address to all subinterfaces of the ICR partition.
■
control-interface —Controls traffic on a subinterface that is part of a backup
partition. When you use this option, the router changes the state of the
corresponding subinterface to Admindown. When the subinterface is in
Admindown state, the router blocks all traffic to the interface. However, the
router does not block advertisements as long as VRRP is running on a separate
subinterface. The router changes the state of the subinterface from Admindown
to Up when the state of the partition changes from backup to master.
■
advertise-mac —Enables the subinterface to transmit GARP advertisements when
the partition moves from backup state to master state. By default, GARP
advertisements are blocked on a subinterface.
Mode
Interface Configuration, Subinterface Configuration
Related Topics
Grouping ICR Subscribers Based on S-VLAN IDs
■
■
Configuring an ICR Partition
ip vrrp icr-partition svlan-list explicit
■ 981
Chapter 10: I Commands