Juniper JUNOSE 10.0.X PHYSICAL LAYER, Руководство по настройке

Страница: 86 / 262

■
Use the no version to restore the default, 1600 bytes.
■
See mtu.
serial description
■
Use to assign a text description or an alias to a serial HDLC interface.
■
You can use this command to help you identify the interface and keep track of
interface connections.
■
The description or alias can be a maximum of 80 characters.
■
Use the show interfaces serial command to display the text description.
■
Example
host1(config-if)# serial description boston09 hdlc channel
■
Use the no version to remove the text description or alias.
■
See serial description.
Configuration Examples
To configure a T3 interface, start at the Global Configuration mode, and issue the
following commands:
host1(config)# controller t3 0/1
host1(config-controll)# no shutdwon
host1(config-controll)# framing c-bit
host1(config-controll)# clock source internal module
host1(config-controll)# cablelength 220
host1# exit
To configure an E3 interface, use the controller e3 command in place of the
controller t3 command.
To configure HDLC channels on a T3 serial interface, issue the following commands:
host1(config)# controller t3 10/0
host1(config-controll)# exit
host1(config)# interface serial 10/0
host1(config-subif)# encapsulation ppp
host1(config-subif)# ip address 192.32.10.2 255.255.255.0
To configure fractional T3 on an interface, issue the following commands:
host1(config)# controller t3 10/0
host1(config-controll)# dsu mode 0
host1(config-controll)# dsu bandwidth 10000
host1(config-controll)# scramble
60 ■
Configuration Examples
JUNOSe 10.0.x Physical Layer Configuration Guide