Juniper JUNOSE 10.0.X PHYSICAL LAYER, Руководство по настройке

Страница: 41 / 262

■
Disable T1 channels.
■
Change the clock source.
■
Assign a text description or an alias to the interface.
■
Change the framing format.
■
Enable or disable SNMP link status processing.
■
Configure FDL messages.
controller t3
Use to specify a T3 controller in slot/port format.
■
■
slot —Number of the slot in which the line module resides in the chassis
■
port —Number of the port on the I/O module
■
Example
host1(config)# controller t3 0/1
■
There is no no version.
■
See controller t3.
t1 clock source
■
Use to configure the transmit clock source for T1 channels.
■
The router supports internal and line clocking .
■
If you specify internal clocking, the interface transmits data using the line
module or the chassis as the internal clock. You must specify one of the
following for internal clocking:
■
module —Specifies internal clock is from the line module itself
■
chassis —Specifies internal clock is from the configured router clock
■
If you specify line clocking, the interface transmits data with a clock recovered
from the line’s receive data stream.
■
Example
host1(config-controll)# t1 2,4-10 clock source line
■
Use the no version to restore the default value, line .
■
See t1 clock source.
t1 description
■
Use to assign a text description or an alias to T1 or fractional T1 channels on a
CT3 module.
■
You can use this command to help you identify the interface and keep track of
interface connections.
■
The description or alias can be a maximum of 80 characters.
Configuration Tasks
■ 15
Chapter 1: Configuring Channelized T3 Interfaces