Juniper JUNOSE 10.0.X PHYSICAL LAYER, Руководство по настройке

Страница: 154 / 262

■
Use to enable SNMP link status processing for a T1 or an E1 interface and its
associated tributary.
■
The default is disabled.
■
Example
host1(config-controll)# path 2 ds1 1/1/1 snmp trap link-status
■
Use the no version to disable SNMP link status processing.
■
See path ds1|e1 snmp trap link-status.
Configuring T1 Interfaces to Send FDL Messages
You can configure a T1 interface to send FDL messages. To configure FDL:
1.
Specify a SONET interface.
host1(config)# controller sonet 8/0
2.
Specify the standard for transmission of FDL messages on both ends of the T1
connection.
host1(config-controll)# path 2 ds1 1/1/1 fdl ansi
3.
(Optional) Configure the interface to operate in an FDL carrier environment.
host1(config-controll)# path 2 ds1 1/1/1 fdl carrier
4.
(Optional) Specify the FDL messages.
host1(config-controll)# path 2 ds1 1/1/1 fdl string eic "ERX-1410"
host1(config-controll)# path 2 ds1 1/1/1 fdl string lic "Bldg 10"
host1(config-controll)# path 2 ds1 1/1/1 fdl string fic "GY788"
host1(config-controll)# path 2 ds1 1/1/1 fdl string unit 080001
5.
Enable transmission of FDL messages.
host1(config-controll)# path 2 ds1 1/1/1 fdl transmit idle-signal
path ds1 fdl
■
Use to specify the FDL standard for the interface.
■
Specify the keyword ansi to support the ANSI FDL standard (see “References”
on page 117).
■
Specify the keyword att to support the AT&T FDL standard (see “References”
on page 117).
■
Specify the keyword all to support both the ANSI and AT&T standards.
■
Specify the keyword none to remove the current FDL mode settings.
■
You can configure a different standard on each T1 channel.
128 ■
Configuration Tasks
JUNOSe 10.0.x Physical Layer Configuration Guide