Juniper JUNOSE 10.0.X PHYSICAL LAYER, Руководство по настройке

Страница: 231 / 262

Duplex Mode: Operational Full Duplex, Administrative Auto Negotiate
Speed: Operational 100 Mbps, Administrative Auto Negotiate
De-bounce: State is Enabled, interval is 2 seconds
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
In: Bytes 39256, Unicast 612
Multicast 0, Broadcast 0
Errors 0, Discards 0, Mac Errors 0, Alignment 0
CRC 0, Too Longs 0, Symbol Errors 0
Out: Bytes 4579036, Unicast 610
Multicast 0, Broadcast 70932
Errors 0, Discards 0, Mac Errors 0, Deferred 0, No Carrier 3
Collisions: Single 0, Multiple 0, Late 0, Excessive 0
ARP Statistics:
In: ARP requests 0, ARP responses 0
Errors 0, Discards 0
Out: ARP requests 0, ARP responses 0
Errors 0, Discards 0
Administrative qos-shaping-mode: none
Operational qos-shaping-mode: none
queue 0: traffic class control, bound to FastEthernet2/0
Queue length 0 bytes
Forwarded packets 1, bytes 46
Dropped committed packets 0, bytes 0
Dropped conformed packets 0, bytes 0
Dropped exceeded packets 0, bytes 0
■
See show interfaces.
show interfaces gigabitEthernet
show interfaces tenGigabitEthernet
■
Use to display the status of Gigabit Ethernet interfaces and 10-Gigabit Ethernet
interfaces.
■
You can specify the following keywords:
■
delta —Specifies that baselined statistics are to be shown
■
brief —Displays the operational status of all configured interfaces
■
Field descriptions
■
GigabitEthernet or tenGigabitEthernet interfaceSpecifier —Status of the
hardware on this interface
■
up—Hardware is operational
■
down—Hardware is not operational
■
Administrative status—Operational state that you configured for this interface
■
up—Interface is enabled
■
down—Interface is disabled
■
Hardware—Type of MAC device on this interface
Monitoring Ethernet Interfaces
■ 205
Chapter 5: Configuring Ethernet Interfaces